Search results for: '1.5" DIN check valve'

The DIN threaded ferrule is one side of a three piece DIN connection. The threaded ferrule connects to the female threaded DIN nut. 304 SS mat. Metric sizes available. Learn More

The DIN cap is used to seal the end of a tube, fitting, or valve which has a DIN threaded ferrule. A gasket and DIN nut will attach the cap. 304 SS mat. Metric sizes available. Learn More

The DIN nut accompanies the plain DIN ferrule and is tightened with a DIN wrench. The nut serves the same function as a clamp in a TC connection. 304 SS mat. Metric sizes available. Learn More

DIN gaskets fit into a threaded DIN ferrule to complete the seal. Learn More

The TC ferrule is one end of a three part connection. This is the most commonly used type of sanitary process pipe connection. Ferrules have 1.125" necks. Longer and shorter necks are available. 304 Stainless Steel. Learn More

The DIN ferrule is one side of a three piece DIN connection. Slip the DIN nut on the tubing before welding the ferrule in place. 304 SS mat. Metric sizes available. Learn More

Valve seats seal the valve body against the disk to stop flow. Learn More

A check valve with a ten pound spring is used with carbonation stone assemblies to prevent product back-flow. Check valves are available with male or female pipe thread connections. Learn More

The stainless steel ball valve has female threaded pipe connections, and is a "full port" valve (the flow is not restricted). 316 SS mat. Learn More

The butterfly valve is used in process flow piping where fractional flow control is required. The valve has a stainless steel body with a silicon valve seat. TC connections shown. Other connections and butt-weld ends available on all butterfly valves. 304 SS mat. Learn More

A TC x FNPT will adapt a TC ferrule to male pipe fittings. One end is a TC, the other is female threaded pipe. 304 SS mat. Learn More

A brass Solenoid Valve is used to regulate coolant. The strength of brass is needed for the constant valve cycling. Learn More

The 3-way level gauge valve will mount to a 1-1/2 IN TC at the base of a ICC NW level gauge system. This valve allows you to isolate the level gauge. 304 SS mat. The sight tube is translucent PFA Teflon. Make sure the tube insert is used at all tubing connections. Learn More

The sample valve is designed to accommodate a CO2 test meter. Learn More

Parts for ICC NW Mixers including: bottom entry, side entry, top entry. Learn More

An AC drive, also known as an adjustable frequency drive (AFD), variable frequency drive (VFD), or inverter drive, is an electronic device used to control the speed and torque of an alternating current (AC) motor. It works by varying the frequency and voltage of the electrical power supplied to the motor, allowing for precise control over its operation. AC drives are commonly used in industrial and commercial applications to optimize energy consumption, improve process control, and extend the lifespan of motors by reducing wear and tear. They are essential components in machinery such as pumps, fans, conveyors, and compressors, where variable speed operation is required. AC drives offer benefits such as energy savings, smoother operation, and the ability to tailor motor performance to specific application requirements. Learn More

The gasket seats between two TC ferrules. Buna is the most common material used for temperature between -22F to +250F. Viton is commonly used for temperature up to 400F Silicone but not for low temperature. Teflon are used for higher temperature applications depending on customer preference. Learn More

The sample valve is designed to accommodate a CO2 test meter. Learn More

A check valve with a ten pound spring is used with carbonation stone assemblies to prevent product back-flow. Check valves are available with male or female pipe thread connections. Learn More

Flange Gaskets. Available in Buna, EPDM, Teflon (PTFE) & Viton (FKM) Learn More