Search results for: 'valve seat 1.5in piton definox'
- Related search terms
- 1.5IN pyrex
- VALVE-SEAT SILICONE 1 1/2IN
- VALVE-LEVEL GAUGE 1 1/2" TC CONNECTION, K10338LL458'
-
Valve SeatsValve seats seal the valve body against the disk to stop flow. Learn MoreAs low as $12.65 -
TC FerruleThe TC ferrule is one end of a three part connection. This is the most commonly used type of sanitary process pipe connection. Ferrules have 1.125" necks. Longer and shorter necks are available. 304 Stainless Steel. Learn MoreAs low as $2.65 -
Ball ValvesThe stainless steel ball valve has female threaded pipe connections, and is a "full port" valve (the flow is not restricted). 316 SS mat. Learn MoreAs low as $48.75 -
TRI CLAMP x FNPTA TC x FNPT will adapt a TC ferrule to male pipe fittings. One end is a TC, the other is female threaded pipe. 304 SS mat. Learn MoreAs low as $10.25 -
Butterfly ValvesThe butterfly valve is used in process flow piping where fractional flow control is required. The valve has a stainless steel body with a silicon valve seat. TC connections shown. Other connections and butt-weld ends available on all butterfly valves. 304 SS mat. Learn MoreAs low as $120.92 -
TC GasketThe gasket seats between two TC ferrules. Buna is the most common material used for temperature between -22F to +250F. Viton is commonly used for temperature up to 400F Silicone but not for low temperature. Teflon are used for higher temperature applications depending on customer preference. Learn MoreAs low as $0.18 -
Solenoid ValveA brass Solenoid Valve is used to regulate coolant. The strength of brass is needed for the constant valve cycling. Learn MoreAs low as $52.81 -
Level Gauge Valve & PartsThe 3-way level gauge valve will mount to a 1-1/2 IN TC at the base of a ICC NW level gauge system. This valve allows you to isolate the level gauge. 304 SS mat. The sight tube is translucent PFA Teflon. Make sure the tube insert is used at all tubing connections. Learn MoreAs low as $1.50 -
Mixer SealsParts for ICC NW Mixers including: bottom entry, side entry, top entry. Learn MoreAs low as $127.50 -
Sample Valve TCThe sample valve is designed to accommodate a CO2 test meter. Learn MoreAs low as $0.78
-
Flange GasketFlange Gaskets. Available in Buna, EPDM, Teflon (PTFE) & Viton (FKM) Learn MoreAs low as $1.28
-
Sample Valve MNPTThe sample valve is designed to accommodate a CO2 test meter. Learn MoreAs low as $0.78
-
Sprayballs & PartsSprayballs are used either for dispersing cleaning solution into a tank, or sparging onto a lauter tun grain bed. The sprayball slips onto tubing with a hairpin clip. 2-1/2 in. sprayballs slip over 1 in. tubing and will clean up to 5 foot diameter vessels. 3-1/2 in. sprayballs slip over 1-1/2 in. tubing and will clean up to 10 foot diameter vessels. Optimum operation: 40 GPM @ 25 PSI. 316 SS mat. Learn MoreAs low as $3.50 -
TRI CLAMP x BARBA TC x barb will adapt a TC ferrule to hose stock. 304 SS mat. Learn MoreAs low as $7.50 -
Replacement Coil - Solenoid ValveA brass Solenoid Valve is used to regulate coolant. The strength of brass is needed for the constant valve cycling. Learn MoreAs low as $56.70 -
TC CapThe TC cap is used to seal the end of a tube, fitting or valve which has a TC ferrule. A gasket and clamp attach the cap. 304 SS mat. Learn MoreAs low as $3.72 -
VALVE-SEAT DIAPHRAGM TC 1.5IN, BREWERY MIX VALVEVALVE-SEAT DIAPHRAGM TC 1.5IN, BREWERY MIX VALVE Learn More$24.00 -
TRI CLAMP x MNPTA TC x MNPT will adapt a TC (TRI-CLAMP) ferrule to female pipe fittings. One end is TC and the other is male threaded pipe. 304 SS mat. Learn MoreAs low as $13.75 -
VALVE-SEAT ALFA LAVAL 'LKB51' SILICONE 1.5INVALVE-SEAT ALFA LAVAL 'LKB51' SILICONE 1 1/2IN Learn More$22.55
