Search results for: 'VALVE-LEVEL GAUGE 1 1/2" TC CONNECTION, K10338LL458'nvOpzp; AND 1=1 OR (<'">iKO)),'
- Related search terms
- 1/2" DIN check valve
- VALVE-LEVEL GAUGE 1 1/2" TC CONNECTION, K10338LL458
- VALVE-LEVEL GAUGE 1 1/2" TC CONNECTION, K10338LL458'
-
SPRING-TCI MW 301 SS SPRING ASSIST ASSYSPRING-TCI MW 301 SS SPRING ASSIST ASSY HI00045 Learn More$57.00 -
TC GasketThe gasket seats between two TC ferrules. Buna is the most common material used for temperature between -22F to +250F. Viton is commonly used for temperature up to 400F Silicone but not for low temperature. Teflon are used for higher temperature applications depending on customer preference. Learn MoreAs low as $0.18 -
Parts for Lauter TunUHMWPE Plates, Rod Wipers, Seals - Everything you need to maintain your lauter tun Learn MoreAs low as $6.60 -
Circuit BreakerA circuit breaker is a safety device designed to protect electrical circuits from overcurrents and short circuits. It automatically interrupts the flow of electricity when it detects an abnormal condition, such as a surge or overload, to prevent damage to the wiring or appliances. Circuit breakers are commonly found in electrical panels and play a crucial role in ensuring the safety and reliability of electrical systems. Learn MoreAs low as $50.00 -
Hot
CONTROL HI-LOW 2-LEVEL 15 1/2" LG SSThe hi-low level control is used to regulate wort receiver levels. Commonly used on both the brewpub open wort receiver and the enclosed airless grant. Wetted parts are 316 Stainless Steel. Learn More$272.27 -
Hot
PRESSURE GAUGE 0-100 PSI 2.5IN DIAL, REAR MOUNT, 1/4IN MNPT CONNThe range of a pressure gauge should be approximately twice the operating pressure of the vessel. Learn More$24.00 -
ThermometerThermometer face is 2-1/2 in. diameter and has a 1/2 in. MNPT threaded connection. Temperature range reads from 0 to 250 deg. F (-20 to 120 deg.C). Learn MoreAs low as $33.00 -
Check ValveA check valve with a ten pound spring is used with carbonation stone assemblies to prevent product back-flow. Check valves are available with male or female pipe thread connections. Learn MoreAs low as $138.00 -
VALVE-SEAT DIAPHRAGM TC 1.5IN, BREWERY MIX VALVEVALVE-SEAT DIAPHRAGM TC 1.5IN, BREWERY MIX VALVE Learn More$24.00 -
Mixer SealsParts for ICC NW Mixers including: bottom entry, side entry, top entry. Learn MoreAs low as $127.50 -
Fuji Temp & PartsThe Fuji controller receives information from the temperature sensor and sends open/close signals to the Heat Transfer Jacket solenoid valve. It can also operate direct fire Burners/Immersion Heaters/Etc. Learn MoreAs low as $198.00 -
TC Cap x TC Ferrule (centered)TC adapters are an economical alternative to a concentric reducer. This fitting is used to reduce the size in process piping where turbulence and complete drainage of the product is not a concern. 304 SS mat. Learn MoreAs low as $13.75 -
Butterfly Valve w/ Micro Metric Handle TC 2INThe multi-position butterfly valve is used in process flow piping where fractional flow control is required. The valve has a stainless steel body with a silicon valve seat. TC connections shown. Other connections and butt-weld ends available on all butterfly valves. 304 SS mat. Learn More$270.90 -
P.R.V.The P.R.V. are available for 2IN, 3IN and 4IN TC vent. Full 304 stainless steel body construction. Learn MoreAs low as $312.00 -
PRESSURE RELIEF VALVE, GUTH VENT, 0.9 LB, 3IN TC, (134-0105)The P.R.V. attaches to a 3IN TC vent. Valve relieves pressure as the fluid level rises while filling a tank Valve relieves vacuum as the fluid level drops while emptying a tank Seals under equal pressure Full body 316 stainless steel construction 1/4" FNPT connection for gas inlet, plug is included Vacuum break: , 0.1 PSI Pressure relief: 0.9 PSI Maximum temperature and pressure rating: 3 PSI @ 70°F Maximum flow rate: 500 GPM Learn More$312.00
